The coin mech has multiple cables,
for the communication side with VM it has both mdb/executive cable and compatibility you can choose,
I use executive socket and settings, then the coin mec do the translation/communication between mdb equipment plugged to it and executive instruction of old VM even if the VM has no mdb plug at all
(but it would have been the same if I plugged the coin mec to MDB of the VM and set to mdb mode for VM communication)
For the internal communication between coin mec and bill acceptor/card reader it use mdb cable and protocol
So actually my setup is executive for the VM/coin mec communication/socket, and mdb between coin mec/card reader and bill acceptor
NECTA SNACKY RY - CARD READER COMMUNICATION PROBLEM
-
- Newbie
- Posts: 5
- Joined: Sun Sep 10, 2023 7:58 pm
- Area Covered: France, Vending snack
- Machines Used: SNACKY RY, CURRENZA C2, SELF2000
- Referred by?: google
-
- Site Admin
- Posts: 3422
- Joined: Tue Jan 13, 2009 9:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
Re: NECTA SNACKY RY - CARD READER COMMUNICATION PROBLEM
Yes i understand dual protocol coin mechs albeit they are old as every mech now is just mdb , single 6 pin plug for mdb and then 2 plugs for exec , 1 for power 1 for communication. Your speaking to old school here, I remember jones connection which was another protocol from the 80s
Ive just never seen an exec protocol card reader before thats all, and never known an evoca machine that can run dual
Ive just never seen an exec protocol card reader before thats all, and never known an evoca machine that can run dual