Hi
My name is joe and I operate in the Kent area.
Can anyone tell me if a clenport coin carrier will fit in a Chinese coin mech.
The centre hole is slightly to small but I was going to file it to make it fit.
Has anyone ever tried this?
New operator
-
Central2vend
- Coin Op Group Regular
- Posts: 160
- Joined: February 22nd, 2015, 8:42 pm
- Area Covered: Kent
- Machines Used: Vending towers
- Referred by?: On google
-
Style
- Coin Op Group Elite
- Posts: 1156
- Joined: June 1st, 2012, 11:00 pm
- Area Covered: Milton Keynes
- Machines Used: Sweet towers, toys, beavers, pringles
- Referred by?: random
Re: New operator
I've swapped them no problem. Never had to file it though
-
Central2vend
- Coin Op Group Regular
- Posts: 160
- Joined: February 22nd, 2015, 8:42 pm
- Area Covered: Kent
- Machines Used: Vending towers
- Referred by?: On google
Re: New operator
Thanks. Style.
When I said Chinese coin mechs they are actually German
Intervened which I think are Chinese.
The hole will only go on spindle about half way
When I said Chinese coin mechs they are actually German
Intervened which I think are Chinese.
The hole will only go on spindle about half way