Anybody had any experience with b2c evolutions? Got one here that seems to be out of sync, dispenses a small amount of water into the co-ex chamber just before the cap makes it across to close the coffee in. Then no more water is dispensed and not a single drop of coffee makes it out. The cycle is completed with "used" coffee being discarded and then the cycle repeats.
The selection timings are set to default. I've tried a few different fresh coffee selections and they all seem to do the same. I've tried resetting the RAM and everything is still the same. When I run a co-ex clean the water runs through it fine so there doesn't seem to be a problem with the water flow. I'm stumped! Any help would be hugely appreciated!
:x B2C Evolution
-
Coin Operated Group
- Site Admin
- Posts: 3414
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
-
Coin Operated Group
- Site Admin
- Posts: 3414
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
Re: :x B2C Evolution
I believe you have to prime the modules with green handle part, its been a while. Crane technical should be able to help, failing that is it leaking when cycling? also have you tried manually adjusting dispense timers?