hi can anybody help me? I've got a Pringles mc that was pulled of the stand on site abduction now the black base of mc has no holes to screw mc to stand. can I just buy a new black base? how do I get the base off to swap it?
regards
rich
pringles mc fix help needed
-
sadler2886
- Coin Op Group Veteren
- Posts: 245
- Joined: October 17th, 2009, 6:55 am
- Area Covered: wv,dy,ws
- Machines Used: tower
- Referred by?: internet
- Location: wolverhampton,dudley,walsall
-
dorsetvending
- Coin Op Group Grand Master
- Posts: 800
- Joined: February 7th, 2009, 5:39 pm
- Area Covered: Dorset/Somerset/Wiltshire
- Machines Used: Bulk/Towers/Pringles
- Referred by?: Yes brother - Glenn Borthwick
- Location: Dorset, Somerset, Devon
Re: pringles mc fix help needed
Roger at Rockvend is your best bet
-
PGBrew
- Coin Op Group Master
- Posts: 740
- Joined: August 10th, 2009, 8:47 am
- Area Covered: London & Home Countie
- Machines Used: Bulk, Tower, Pringles & various toys
- Referred by?: Sarah Hickman
- Location: London & Home Counties North of Thames
Re: pringles mc fix help needed
I've got a few baseless Clenports, same problem!