Managed to get my key stuck in the lock of one of my towers today, it went in turned a fraction and then jammed, now it won't move and it will not come out. Tower has been taken apart but no joy. This is the 2nd time I've done this, I ended up breaking the lock 1st time......can anyone give me advice.
Cheers
Gus
Stuck Key
-
rockhopper
- Coin Op Group Apprentice

- Posts: 32
- Joined: October 23rd, 2012, 11:10 am
- Referred by?: browsing the web
-
part-time-operator
- Coin Op Group Veteren

- Posts: 273
- Joined: December 30th, 2011, 6:01 pm
- Referred by?: Reader
Re: Stuck Key
your lock is busted i am guessing, perhaps you got them 2nd hand? there are some little widgets in the lock which seem to pop out. try using a filed down key if you have a number of these towers, that way if it does jam up you can at least get the key out and come back to the site with a replacement tower.
-
PGBrew
- Coin Op Group Master

- Posts: 741
- Joined: August 10th, 2009, 8:47 am
- Area Covered: London & Home Countie
- Machines Used: Bulk, Tower, Pringles & various toys
- Referred by?: Sarah Hickman
- Location: London & Home Counties North of Thames
Re: Stuck Key
Use a hacksaw to cut the lock off. Then replace lock. This can be done on site.
Pete
Pete
-
rockhopper
- Coin Op Group Apprentice

- Posts: 32
- Joined: October 23rd, 2012, 11:10 am
- Referred by?: browsing the web
Re: Stuck Key
Thanks for the info, I have ordered a couple of new locks as no doubt this will happen again.
Gus
Gus