discarpa mech

Got a vending technical question you need answered?
Post Reply
Ade
Coin Op Group Grand Master
Coin Op Group Grand Master
Posts: 852
Joined: July 6th, 2009, 7:43 pm
Area Covered: east and west midlands
Machines Used: kiddie rides, sweet and toy vend
Referred by?: M.Slater
Location: tamworth & b`ham + surrounding areas

discarpa mech

Post by Ade »

cannot for the life of me get the screw on the back undone, any ideas anyone :wtf:

cheers

Ade
You do not have the required permissions to view the files attached to this post.
dorsetvending
Coin Op Group Grand Master
Coin Op Group Grand Master
Posts: 800
Joined: February 7th, 2009, 5:39 pm
Area Covered: Dorset/Somerset/Wiltshire
Machines Used: Bulk/Towers/Pringles
Referred by?: Yes brother - Glenn Borthwick
Location: Dorset, Somerset, Devon

Re: discarpa mech

Post by dorsetvending »

Shock it with a big hammer as it sometimes helps binding threads. Also if helps place elastic band in the screw as it helps the grip.
Ade
Coin Op Group Grand Master
Coin Op Group Grand Master
Posts: 852
Joined: July 6th, 2009, 7:43 pm
Area Covered: east and west midlands
Machines Used: kiddie rides, sweet and toy vend
Referred by?: M.Slater
Location: tamworth & b`ham + surrounding areas

Re: discarpa mech

Post by Ade »

cheers gav, had a result and a big thanks to jay for his idea also lynda at ska vend had same idea and it worked, i cut into housing that screw goes into via an hacksaw took metal away and then took screw out via a pair of grips, machine fully operational now.

thanks all again

regards

Ade
Post Reply