Can anyone confirm the folloing below:
I understand that Clenports are differnet size to Chinese-can anyone confirm if tubz vending/Snack A Can are the same segments?
Thanks
Malcolm
Plastic Segments
-
Eatsweets
- Coin Op Group Regular
- Posts: 134
- Joined: June 3rd, 2011, 10:36 am
- Area Covered: Hertfordshire and essex
- Machines Used: Tower vending
- Referred by?: Phil hollingdale
Re: Plastic Segments
I think that as long as the top ring and the bottom ring are the right rings for the machine then the rest in the middle don't matter, I am sure it's been tried and worked before.
One of the hardened vending guys will be able to confirm.
Regards
Rob
One of the hardened vending guys will be able to confirm.
Regards
Rob
-
sadler2886
- Coin Op Group Veteren
- Posts: 245
- Joined: October 17th, 2009, 6:55 am
- Area Covered: wv,dy,ws
- Machines Used: tower
- Referred by?: internet
- Location: wolverhampton,dudley,walsall
Re: Plastic Segments
That is correct.
Regards
Rich
Regards
Rich
-
choice vending
- Coin Op Group Veteren
- Posts: 239
- Joined: January 20th, 2009, 5:39 pm
- Area Covered: walsall, north bham, A5 area
- Machines Used: towers, bulk vendors, kiddies rides, football tabl
- Location: Walsall, Bham, tamworth, cannock,and surrounding areas in the West Midlands
Re: Plastic Segments
You will also need to use the correct dimple ring to match teh machines and the segments on the bottom segment. 12mm dimples on the chinese machines with the 3 notches been the thin notches, and 18mm dimples on the clemports with the 3 fatter notches