sweet tower problem
-
- Coin Op Group Master
- Posts: 450
- Joined: January 20th, 2009, 9:38 pm
- Area Covered: devon dorset somerset
- Machines Used: bulk tower toy condoms
Re: sweet tower problem
by the way you will be amazed how much easier a coin mech goes back in if you turn the machine upside down
-
- Coin Op Group Grand Master
- Posts: 800
- Joined: February 7th, 2009, 5:39 pm
- Area Covered: Dorset/Somerset/Wiltshire
- Machines Used: Bulk/Towers/Pringles
- Referred by?: Yes brother - Glenn Borthwick
- Location: Dorset, Somerset, Devon
Re: sweet tower problem
Be an interesting specialist subject in the Mastermind seat.....
-
- Coin Op Group Elite
- Posts: 1046
- Joined: January 15th, 2009, 9:05 pm
- Area Covered: Southern Ireland
- Machines Used: Towers, Pringles, Condoms, Capsules, Pokers,Toys
- Referred by?: 1
Re: sweet tower problem
Dead right Gavin. lol "you have 3 minutes to answer as many questions as possible on nipple tweaking".
-
- Coin Op Group Grand Master
- Posts: 800
- Joined: February 7th, 2009, 5:39 pm
- Area Covered: Dorset/Somerset/Wiltshire
- Machines Used: Bulk/Towers/Pringles
- Referred by?: Yes brother - Glenn Borthwick
- Location: Dorset, Somerset, Devon
Re: sweet tower problem
It's alot easier to get a few quid out of those kids who fiddle your machines - You just turn them upside them and their pocket money drops out lol
-
- Coin Op Group Apprentice
- Posts: 39
- Joined: October 17th, 2011, 5:15 pm
- Area Covered: Wales Dorset Hampshire
- Referred by?: google
Re: sweet tower problem
I was laughing when typing nipple circles, but felt it was childish and immature to be amused by it - glad to see people on here have the same sense of humour.
-
- Coin Op Group Master
- Posts: 740
- Joined: August 10th, 2009, 8:47 am
- Area Covered: London & Home Countie
- Machines Used: Bulk, Tower, Pringles & various toys
- Referred by?: Sarah Hickman
- Location: London & Home Counties North of Thames
Re: sweet tower problem
There are three lugs on the nipple circle where the clear plactic rings slot in, sometimes the securing protusions on the inside of the rings break off and get wedged in these lugs. To prevent the problem happening again it is important to clear out the debris from these lugs and also swap the ring over with the one above.
Pete
Pete