Hi,
Just wanted to ask if it is OK to power a tabletop coffee vending machine through a single socket (gang) 10m extension lead as the wall socket is not close to where the machine has been placed?
Does anyone power their vending machines through an extension lead?
Thanks
Extension lead for a vending machine
-
- Newbie
- Posts: 5
- Joined: October 2nd, 2022, 4:36 pm
- Area Covered: Birmingham
- Referred by?: Google search
- Coin Operated Group
- Site Admin
- Posts: 3421
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
Re: Extension lead for a vending machine
yes it s fine unwind the extension lead fully though
-
- Coin Op Group Apprentice
- Posts: 32
- Joined: February 15th, 2022, 5:57 pm
- Area Covered: Liverpool
- Machines Used: Polyvend
- Referred by?: Google
Re: Extension lead for a vending machine
hi would extension lead still be suitable for a full size vending machine i.e a polyvend combi machine?
thanks
thanks
- Coin Operated Group
- Site Admin
- Posts: 3421
- Joined: January 13th, 2009, 10:41 am
- Area Covered: Birmingham, West Midlands
- Machines Used: Arcade Machines, Quiz & Big Vendors
- Referred by?: myself
- Location: Birmingham
- Contact:
Re: Extension lead for a vending machine
yes, without going into too much detail, one would not be an issue as long as not on a wind up extention lead not unwound
-
- Coin Op Group Apprentice
- Posts: 32
- Joined: February 15th, 2022, 5:57 pm
- Area Covered: Liverpool
- Machines Used: Polyvend
- Referred by?: Google
Re: Extension lead for a vending machine
just wanted to make sure