Plastic break in machine
-
dorsetvending
- Coin Op Group Grand Master
- Posts: 800
- Joined: February 7th, 2009, 5:39 pm
- Area Covered: Dorset/Somerset/Wiltshire
- Machines Used: Bulk/Towers/Pringles
- Referred by?: Yes brother - Glenn Borthwick
- Location: Dorset, Somerset, Devon
Plastic break in machine
I have an american gumball vendor from Toyvend. Called a Vortex. It has an annoying crack down one side at bottomnwhere clumsy oaf of a site owner lumps it in and out. Any ideas on a decent fix of this split plastic base?
-
Ade
- Coin Op Group Grand Master
- Posts: 852
- Joined: July 6th, 2009, 7:43 pm
- Area Covered: east and west midlands
- Machines Used: kiddie rides, sweet and toy vend
- Referred by?: M.Slater
- Location: tamworth & b`ham + surrounding areas
Re: Plastic break in machine
super glue then cover it with piece of electrical tape of same colour, do this with chinese towers where plastic breaks away from base
Ade
Ade
-
dorsetvending
- Coin Op Group Grand Master
- Posts: 800
- Joined: February 7th, 2009, 5:39 pm
- Area Covered: Dorset/Somerset/Wiltshire
- Machines Used: Bulk/Towers/Pringles
- Referred by?: Yes brother - Glenn Borthwick
- Location: Dorset, Somerset, Devon
Re: Plastic break in machine
Top idea cheers Ade 
-
PGBrew
- Coin Op Group Master
- Posts: 740
- Joined: August 10th, 2009, 8:47 am
- Area Covered: London & Home Countie
- Machines Used: Bulk, Tower, Pringles & various toys
- Referred by?: Sarah Hickman
- Location: London & Home Counties North of Thames
Re: Plastic break in machine
I use Duck Tape over splits, does'nt look to bad and holds well.